Professional China Handheld Temperature And Humidity Sensor – Handheld digital temperature relative humidity data recorder meter portable hygrometer for storerooms, buildings – HENGKO

Note: The equipment (humidity meter) and probes must be under stable temperature and humidity conditions to give a reliable and stable value.

For example, at 50% RH, 23°C, a temperature difference of 1°C will produce an error of approximately 3% RH.

The equipment does not have to be turned on during the acclimation period of up to about 30 minutes.

The length of the acclimation period of the device depends on several factors：

-After the start of the measurement, a large deviation of the temperature and humidity values between the probe and the medium.

-Changes in measurements during the stabilization period

-When performing humidity measurements, the device can show better environmental adaptation, provide values more quickly than temperature measurements, and is more sensitive.

And more sensitive. The value after the decimal point only shows the trend of the data, and when the displayed value reaches an average, the adjustment  is complete.

For paper pallets, straw pallets and other such applications

Model HK-J8A102 handheld humidity meter is designed for measuring paper stacks, straw stacks, and other such applications. It is best suited for measuring the smallest possible heat content between the probe and the paper stack by placing the probe into the paper stack. The paper layer above the measured position has to be lifted slightly. The friction between the sword-shaped probe and the paper layer should be avoided as much as possible since it generates heat and prolongs the measurement time.

For the same reason, friction should also be avoided when pulling out the probe to be inserted into another paper stack for measurement.
It is advisable to pause for about 30 seconds during the measurement process. Then use the probe to measure a new sheet of paper. This will speed up the measurement since the water quality needs to be supplied to the probe quickly. Avoid touching the probe. (to avoid temperature effects).

For powders, granules, cereals, large bales, etc., application.

HK-J8A102 handheld hygrometer humidity and temperature meter is equipped with a (sintered sensor housing)dust filter (which can be easily removed for cleaning by twisting off the probe mounting end). It can be used for large amounts of non-sticky material without clogging the filter and affecting the measurement.

Measurement of residual humidity on walls and concrete floors is possible (= equilibrium humidity %rh). The sintered probe end must be fully inserted into the substance. Temperature and humidity are measured when the temperature is constant.